Ten points for attention in quality Control of sticking process of carton sticking Machine
A. Understand the work flow of adhesive box machine, understand the work order, especially if there are special requirements in the note bar;
B.Carry on the first inspection to the sticky box product and fill in the quality inspection record form in time.
The sticking box of the box-sticking machine can not have the phenomena of degumming, foaming, false bonding, oil stain and leakage printing;
The quantity and height of the finished product are the same, the finished product is stacked neatly, and the specification of filling out the finished product card is clear.
The packing direction and quantity of the adhesive box of the adhesive box machine shall be carried out according to the requirements of the customers. The same product shall not be used as the cushioning paper with its bad products, and the medicine box and the bad paperboard shall not be used as the cushioning paper.
4.There can be no running position, explosion line, half whether to wear the phenomenon, after the two models should be attached to the product to pay special attention to.
5.There can be no running position, explosion line, half whether to wear the phenomenon, after the two models should be attached to the product to pay special attention to.
6.Special products are produced strictly according to this operation instruction, and the special board is special.
7.When gluing, check the paper first, and then check if there are any defects on both sides of the flutter, whether the slot at the shallow pressure is running, the line is burst, there is no bruise, and the scratch is not.
8. The bond is firm and it is not easy to pull away。
9.The seam clearance is controlled at 3 ≤ 9mm, and the standard clearance 6mm.
10.Compared with slotted clearance, the deviation of tongue is not more than 3mm, and the difference of scissors is not greater than that of 3mm.
